Knowledge

Precautions for installation of high-temperature solenoid valves

The working principle of a high-temperature electromagnetic valve: After the electromagnetic iron is energized, the connecting rod is lifted and starts to rotate with the shaft, which acts on the pilot valve and opens the main valve; After the power is cut off, under the weight of the armature and the action of the return spring, close the pilot valve. After the pilot valve is closed, close the main valve by the pressure difference.

 

Precautions for installing high-temperature solenoid valves:

 

1. When installing, the solenoid valve coil should be facing upwards and kept in a vertical position. The arrow or mark on the solenoid valve should be consistent with the flow direction of the pipeline and should not be installed in areas with splashes or leaks.

 

2. The working medium of the solenoid valve should be clean and free of particulate impurities. The dirt and filters on the surface of the solenoid valve components should be regularly cleaned.

 

3. When the solenoid valve malfunctions, in order to isolate the solenoid valve in a timely manner and ensure the normal operation of the system, it is necessary to install a bypass device

 

4. In pipeline systems, the diameter of the solenoid valve installed on the branch should be smaller than the diameter of the main pipeline valve.

 

5. Before installing the solenoid valve, the pipeline must be cleaned thoroughly. It is recommended to install a filter in front of the valve and a drain valve in the steam pipeline.

 

6. Valves should not be installed in the low recesses of the pipeline to avoid obstruction of operation due to steam condensation, impurities, etc. settling inside the valve.

 

7. Cannot be used in explosive hazardous environments.

 

8. In the case of insufficient pipeline rigidity, it is recommended to fix the pipeline in front of the valve with a bracket to avoid vibration caused by the operation of the solenoid valve.

 

9. Before installation, pay attention to reading the product label, carefully read the user manual, and determine whether the product meets the usage conditions.

 

10. Pressure gauges need to be installed on the front and rear pipelines of the solenoid valve to observe the pipeline pressure.

You Might Also Like

Send Inquiry